UCT Pillow block
| Attribute | Value |
|---|---|
| Shaft diameter | 25 mm |
| Housing overall width | 32 mm |
| Bearing width, total | 34 mm |
| Basic dynamic load rating | 14 kN |
| Basic static load rating | 7.8 kN |
| Limiting speed | 5,850 r/min |
| Housing type | Take-up |
| Retaining feature, inner ring | Set screws |
| Bore type | Cylindrical |
| Rubber seating ring | Without |
| Material, housing | Cast iron |
| Material, bearing | Bearing steel |
| Coating | Without |
| Sealing, bearing | Seal and flinger on both sides |
| Sealing type | Contact, standard |
| Sealing, unit | Optional end cover |
| Lubricant | Grease |
| Relubrication hole | With |
| Grease fitting | With mm |
Description
UCT pillow block bearings –
Consisting of an insert bearing based on a sealed deep groove ball bearing mounted in a grey cast iron housing.
Typically mounted in take-up frames, the unit has an inner ring extended on both sides and is locked by tightening two set screws on the inner ring, which makes it easy to mount.
Units with designation suffix /H feature a 120° angle of separation between the set screws that contributes to a higher stability and a better load balance.
Designed for an alternating rotation
Quick and easy to mount onto the shaft
Accommodate static initial misalignment
Long service life
Reduced noise and vibration levels
Only logged in customers who have purchased this product may leave a review.
Reviews
There are no reviews yet.